Kitchen Faucet Installation In Columbus

Labor alone runs $120 to $250 for a standard replacement, and $250 to $600 total including a mid-range faucet. Plumbers charge $45 to $200 per hour and usually finish in 30 minutes to an hour. Prices fall inside these ranges. Costs rise if the shut-off valves need replacing, the supply lines are corroded, or the countertop needs drilling. Installing a new sink and faucet together runs $600 to $2,000. Removing and disposing of the old faucet adds $15 to $80.

Count the mounting holes first. One hole takes a single-handle faucet; two allows a faucet plus a sprayer or soap dispenser; three or four fits a double-handle setup or a single-handle model with a deck plate covering the extras. Kitchen three-hole sinks are usually 8 inches center to center. Also measure the clearance from the deck to any cabinet above so a high-arc spout fits. Plumbers confirm this before ordering. Ordering the wrong configuration is the most common mistake.

Yes, if the shut-off valves still turn and the new faucet matches your hole configuration. Modern faucets use braided flexible supply lines, so it’s mostly tightening nuts in a cramped cabinet; budget one to two hours and $30 to $150 in materials. A basin wrench helps enormously. Call a plumber if the valves won’t close, the supply lines are corroded steel, you’re installing a wall-mounted model, or new holes need drilling. Forcing a seized valve is how this becomes an emergency.

Yes. Motion-activated and touch faucets need power under the sink; most run on batteries, but plug-in models require an unswitched outlet in the cabinet. If your kitchen doesn’t have one, adding it means an electrician at roughly $100 to $250. Battery models avoid that but need cells replaced every one to two years. Sensor faucets also take longer to set up and calibrate than a standard model. Ask installers which type your kitchen setup supports before you buy.

A plumber typically finishes in 30 minutes to an hour on a like-for-like swap. Two hours if the sink and drain are being connected at the same time. Complex jobs new piping, drilled holes, a wall-mounted model can stretch to seven or eight hours. DIY takes one to two hours for a first attempt, sometimes longer. Clear everything out from under the sink before your plumber arrives; most bill by the hour.

Replace it once the faucet is 15 years or older, visibly corroded, or leaking from the body rather than the handle. A quality kitchen faucet lasts 15 to 20 years; budget models start failing around year eight. Repair makes sense for a drip, a worn cartridge, or a broken sprayer head; sprayers often replace separately for far less than a whole faucet. Weak flow and repeated rebuilds point to replacement. Plumbers can price both options in one visit.

A handyman charges $50 to $80 an hour versus $75 to $150 for a licensed plumber and can manage a straightforward like-for-like swap. The tradeoff: handymen typically aren’t licensed or insured for plumbing, so damage from a bad connection may land on you. Hire a licensed plumber if shut-off valves need replacing, pipes need modification, or you’re adding a water filter, hot water dispenser, or wall-mounted faucet. For a basic swap with working valves, either one works fine.