Bathroom Faucet Installation In Columbus

Expect $150 to $600 total for a standard bathroom faucet installation, with labor running $130 to $350 and the faucet itself $70 to $250 for most models. Plumbers charge $45 to $150 per hour and typically bill one to two hours. Prices usually fall inside these ranges. Costs climb if the shut-off valves need replacing ($150 to $850 for pipe work), the countertop needs new holes drilled, or you’re installing a wall-mounted or vessel model. Higher-end brass fixtures alone run $200 to $600.

A leak at the base of a faucet, where it meets the countertop or sink, usually points to a damaged cartridge assembly allowing water to bypass the faucet body, a pinhole leak in the pull-out sprayer hose, or worn O-rings around the faucet body itself. If the leak is coming specifically from underneath the base and not from the handles or sprayer, it may indicate internal damage to the faucet body that makes replacement the more sensible option. A plumber can quickly tell you which situation you’re dealing with.

Yes, if the shut-off valves under the sink actually work and the old faucet isn’t rusted solid. Most people rate it a 2 or 3 out of 5 in difficulty; the challenge is working upside down in a tight cabinet, not the plumbing itself. Budget one to four hours for a first attempt versus one to two for a pro. Call a plumber instead if the valves won’t close, the supply lines are corroded, or you’re switching faucet types and need holes drilled.

About one hour for a straightforward swap, or up to two if the drain assembly and pop-up stopper are being replaced at the same time. Wall-mounted and freestanding models take considerably longer because the plumbing runs inside the wall or floor; those jobs can stretch to a full day. Most plumbers schedule faucet work as a single short appointment, so clearing everything out from under the vanity before they arrive saves billable time. Ask whether the quote covers travel and disposal of the old fixture.

Count the holes in your sink or countertop and measure the spread the distance from the center of the far-left hole to the center of the far-right one. One hole means a single-hole faucet. Three holes at four inches apart means a centerset. Three holes at eight to sixteen inches apart means widespread. A deck plate lets a single-hole faucet cover a three-hole sink, but the reverse doesn’t work without drilling. Plumbers will verify this measurement before you order anything.

Replace it if the faucet is 15 years or older, visibly corroded, or has a body crack; a new cartridge won’t save a fixture that’s already deteriorating. Repair makes sense for a single dripping handle or a worn washer on a faucet under about 10 years old, since cartridges and O-rings cost $10 to $50. A quality faucet lasts 10 to 20 years; budget models often start failing around year eight. Plumbers can usually tell you which applies during the estimate.

A handyman can handle a simple like-for-like swap and charges $50 to $80 per hour versus $75 to $150 for a licensed plumber. The tradeoff is that handymen usually aren’t licensed or insured for plumbing work, so damage from a bad connection may be on you. Hire a licensed plumber whenever shut-off valves need replacing, pipes need modification, or the install involves wall-mounted plumbing. For a basic vanity faucet with working valves, either can do the job safely.

Most major brands offer a limited lifetime warranty on the faucet body and finish for the original homeowner, with electronic or touchless components covered for around five years. That covers the part; labor to remove and reinstall it is separate unless your plumber offers their own guarantee. Ask any installer what they warrant on workmanship; one year on labor is common. Keep the receipt and model number, since manufacturers almost always require proof of purchase to honor a claim.